-9%

Ublox NEO 7M GPS With Compass for APM 2.6/2.8 and Pixhawk 2.4.6/2.4.8

1,600.00 1,450.00

QUICK OVERVIEW

  1. Tracking sensitivity: 161 dBm
  2. Capture sensitivity : 148 dBm
  3. cold start time: 38s average
  4. Warm start time: 35s average
  5. hot start time: 1s average
  6. Capture time: 0.1s Average
Category:

Description

Ublox Neo 7M GPS module that includes an HMC5883L digital compass.  The new Ublox NEO 7 series is a high sensitivity, low power GPS module that has 56 channels and outputs precise position updates at 10Hz.  This GPS module also comes with a molded plastic case which keeps the module protected against the elements making it ideal for use on your aircraft or quadcopter.

This Ublox Neo 7M GPS module uses an active circuitry ceramic patch antenna to provide excellent GPS signal which outperforms the older Ublox Neo 6 series modules.   This Ublox Neo 7 module also includes a rechargeable backup battery to allow for HOT starts and also includes an I²C EEPROM to store the configuration settings.  Out of the box this GPS module is configured to run at 38400 Baud and is configured to run with APM/Pixhawk systems.  This GPS module includes two cables, a 6pin connector for the GPS module and a 4 pin connector for the i2c compass.

Note:

  • APM 2.5 and APM 2.0 have an internal compass (unlike APM 2.6) which must be disabled by cutting a trace before you can connect the 3DR UBlox GPS + Compass module (the video here shows how).
  • Other than disabling the internal compass, connecting the UBlox is the same for APM2.0/APM2.5 as for APM2.6.

 Features :

  1. Locate performance
  2. These are Pre-configured, Flashed with the correct settings, and tested. To make them Plug and Play.
  3. Super Bright LED
  4. Backplane with Standard Mk style mounting holes 45mm X 45mm
  5. 38400 bps (Default) Changed to 115200bps!
  6. Output GGA, GSA and RMC frames
  7. 1Hz (Default) Changed to 5Hz!
  8. Permanent Configuration Retention
  9. compass on board
  10. 6 pin connector for EZ connect to MEGA BLACK
  11. 4 pin connector for only GPS use
  12. 4 pin connector for compass only use
  13. Can use both 4 pin at once.

Specification:

Model Ublox NEO 7M
Receiver Type 56 Channels
Galileo E1B/C1
GPS L1C/A
QZSS L1C/A
SBAS L1C/A
Receiver Frequency L1 [1575.42MHz]
Supply Voltage (V) +3.5V~+5.5V
Main Chip U-BLOX NEO-7M
Sensitivity Cold Start (without aiding): -147 dBm
Hot Start: -155 dBm
Reacquisition: -160 dBm
Tracking & Navigation: -161 dBm
Position Accuracy Autonomous: 2.5 m
SBAS: 2.0 m
Acceleration <4g
Navigation Update Rate 5Hz
Operating Temperature Range -24ºC ~ 84°C
Tracking Sensitivity -161 dBm
Co-Ordinate System WGS-84
Capture Time 0.1s Average
Cold Start Time 38s Average
Warm Start Time 35s Average
Boot Time 1s Average
Maximum Altitude 18000
Maximum Speed 515 m/s
Dimensions (mm) LxWxH 60 x 11.5 (DxH)
Weight (gm) 26
Cable Length 20 cm
Shipment Dimensions 8 × 8 × 5 cm

Package Includes :

1 x Ublox Neo 7M GPS module.

Reviews

There are no reviews yet.

Be the first to review “Ublox NEO 7M GPS With Compass for APM 2.6/2.8 and Pixhawk 2.4.6/2.4.8”

Your email address will not be published. Required fields are marked *